Motorola WiNG 5.5 Reference Manual page 259

Enable Motion Sensor
Enable Humidity Sensor
7. Define or override the following
Polling Interval for All
Sensors
8. Select OK to save the changes made to the environmental sensor screen. Select
configuration.
Select this option to enable the module's motion sensor. Results are reported back to the
access point's Environment screens within the Statistics node. This setting is enabled by
default.
Select this option to enable the module's humidity sensor. Results are reported back to the
access point's Environment screens within the Statistics node. This setting is enabled by
default.
Shared Configuration setting:
Set an interval in either Seconds (1 - 100) or Minutes (1 - 2) for the time between all
environmental polling (both light and environment). The default setting is 5 seconds.
Device Configuration 5 - 173
Reset to revert to the last saved