Motorola WiNG 5.5 Reference Manual page 301

Figure 5-134 Device Overrides – Virtual Interfaces Dynamic Routing screen
19. Refer to the following to configure
Priority
Cost
Bandwidth
20. Configure the OSPF Authentication Type
null, simple-password and message-digest.
OSPF Settings.
Select this option to enable or disable OSPF priority settings. Use the spinner to configure
a value from 0 - 255. This option sets the priority of this interface becoming the Designated
Router (DR) for the network. DRs provide routing updates to the network by maintaining a
complete topology table of the network and sends the updates to the other routers in the
network using multicast. Setting a high value increases the chance of this interface
becoming a DR. Setting this value to Zero (0) prevents this interface from being elected a
DR.
Select this option to enable or disable OSPF cost settings. Use the spinner to configure a
cost value from 1 - 65535. Use this option to set the OSPF cost of this interface. OSPF cost
is the overhead required to send a packet over this interface.
Select this option to enable or disable OSPF bandwidth settings. Use the spinner to
configure a bandwidth settings from 1 - 10,000,000 KBps. Use this option to set the
bandwidth of this interface in KBps.
settings by selecting from the drop-down list. The available options are None,
Device Configuration 5 - 215