Motorola WiNG 5.5 Reference Manual page 164

5 - 78 WiNG 5.5 Access Point System Reference Guide
6. Select the Policy Based Routing
select the Edit
7. Select Add Row +
8. Add IP addresses and network masks in the
9. Provide the Gateway
10. Refer to the Default Route Priority
Static Default Route
Priority
DHCP Client Default Route
Priority
Enable Routing Failure
11. Select the OK
configuration.
policy to apply to this profile. Select the
icon to edit an existing policy after selecting it in the drop-down list.
as needed to include single rows with in the static IPv4 route table.
used to route traffic.
field and set the following parameters:
Use the spinner control to set the priority value (1 - 8,000) for the default static route.
This is weight assigned to this route versus others that have been defined. The default
setting is 100.
Use the spinner control to set the priority value (1 - 8,000) for the default route learnt
from the DHCP client. The default setting is 1000.
When selected, all default gateways are monitored for activity. The system will failover
to a live gateway if the current gateway becomes unusable. This feature is enabled by
default.
button located at the bottom right of the screen to save the changes. Select
Network Address column of the
Create icon to create a policy based route or
Static Routes table.
Reset to revert to the last saved