Motorola WiNG 5.5 Reference Manual page 330

5 - 244 WiNG 5.5 Access Point System Reference Guide
Use Tunnel Policy
Local Hostname
Local Router ID
Establishment Criteria
VRRP Group
Critical Resource
12. Refer to the Peer table
13. Select + Add Row
Figure 5-151 Device Overrides - Network - L2TPv3 screen, Add L2TP Peer Configuration
Select the L2TPv3 tunnel policy. The policy consists of user defined values for protocol
specific parameters which can be used with different tunnels. If none is available a new
policy can be created or an existing one can be modified. For more information, refer to
Configuring Captive Portal Policies on page
Provide the tunnel specific hostname used by this tunnel. This is the hostname advertised
in tunnel establishment messages.
Specify the router ID sent in tunnel establishment messages with a potential peer device.
Specify the establishment criteria for creating a tunnel. The tunnel is only created if this
device is one of the following:
• vrrp-master
• cluster-master
• rf-domain-manager
The tunnel is always created if Always is selected. This indicates that the device need not
be any one of the above three (3) to establish a tunnel.
Set the VRRP group value. This is only applicable if the Establishment Criteria specifies
vrrp-master.
This table lists the critical resources defined for this system. The tunnel is created and
maintained if the critical resources are available. The tunnel is brought down if any one
of the defined critical resource goes down or is unreachable.
to review the configurations of the peers available for tunnel connection.
to populate the table with a maximum of two peer configurations.
9-2.