Motorola WiNG 5.5 Reference Manual page 539

Reconnect Attempts
Reconnect Interval
Retry Count
Retry Time Out
Rx Window Size
Tx Window Size
Failover Delay
Force L2 Path
Recovery
6. Select OK to save the updates to the L2TP V3 Policy Details. Select
Use the spinner control to set a value (from 0 - 250) representing the maximum number of
reconnection attempts initiated to reestablish the tunnel. The default interval is 0.
Define an interval in either Seconds (1 - 3,600), Minutes (1 -60) or Hours (1) between two
successive reconnection attempts. The default setting is 2 minutes.
Use the spinner control to define how many retransmission attempts are made before
determining a target tunnel peer is not reachable. The available range is from 1 - 10, with a
default value of 5.
Use the spinner control to define the interval (in seconds) before initiating a retransmission
of a L2TP V3 signaling message. The available range is from 1 - 250, with a default value of 5.
Specify the number of packets that can be received without sending an acknowledgement.
The available range is from 1 - 15, with a default setting of 10.
Specify the number of packets that can be transmitted without receiving an
acknowledgement. The available range is from 1 - 15, with a default setting of 10.
Specify the wait time (in seconds) before re-establishing a failed tunnel.The available
duration is 5 - 60 seconds or 1 minute with a default setting of 5 seconds.
Select to enable forcing the discovery of servers, gateways and other networks behind a
L2TPV3 tunnel when a tunnel is being established or when a failed tunnel is being
reestablished.
Network configuration 7 - 11
Reset to revert to the last saved configuration.