Motorola WiNG 5.5 Reference Manual page 283

7. Select + Add Row below the
resources used it obtain system time. Set the following parameters to define the NTP configuration:
AutoKey
Key
Prefer
Server IP
Version
8. Refer to the RF Domain Manager
9. Select the Capable option to enable or disable this device as a RF Domain manager.
10. Select the Priority option to enable configuring a priority value for this device when election to become a Domain Manager
is conducted. Set a value using the spinner control. Setting a low value increases the chance of this device becoming the
RF Domain manager.
11. Select OK to save the changes and overrides made to the general profile configuration. Select
saved configuration.
Refer to the following to complete the override of the access point's entire profile configuration:
• Radio Power Overrides
• Adoption Overrides
• Profile Interface Override Configuration
• Overriding the Network Configuration
• WAN Backhaul Overrides
• Overriding a Security Configuration
• Overriding a Services Configuration
• Overriding a Management Configuration
• Overriding an Advanced Configuration
• Overriding Mesh Point Configuration
• Overriding Environmental Sensor Configuration
Network Time Protocol (NTP)
Select this option to enable an autokey configuration for the NTP resource. This is a key
randomly generated for use between the access point and its NTP resource. The default
setting is disabled.
If an autokey is not being utilized, you must manually enter a 64 character maximum key
shared for interoperation.
Select this option to designate this particular NTP resource as preferred. If designating
multiple NTP resources, preferred resources will be given first opportunity to connect to
and provide NTP calibration.
Set the IP address of each server added as a potential NTP resource.
Use the spinner control to specify the version number used by this NTP server resource.
The default setting is 0.
field to configure this device as a RF Domain manager.
Device Configuration 5 - 197
table to define (or override) the configurations of NTP server
Reset to revert to the last