In Case Of Options(Cst. Feeding Unit) - Canon imageRUNNER 2530 Service Manual

9) AT the rear side of the Cassette Module, pull out the connector at the heater side and the connect the connecter.
MEMO:
When performing
this procedure, it
is not necessary to
remove the main
body. However, the
figure shows the
picture without the
main body to
show easily.

In case of Options(CST. Feeding Unit)

1) Remove the cassette. 2) Remove the Heater Connector Cover using a flat-blade screwdriver.
•
1 Claw
•
2 Protrusions
9
Installation > Cassette Heater Unit 37 > Installation Procedure > In case of Options(CST. Feeding Unit)
Claw
Protrusions
Heater Connector Cover
9 Installation > Cassette Heater Unit 37 > Installation Procedure > In case of Options(CST. Feeding Unit)
10) Install the Lower rear cover
11) Connect the 4 Connectors.
12) Install the Connector Cover.
13) Install the removed Cassettes.
14) Check that the Environment Heater switch is ON
15) Plug the power plug of the host machine to the
outlet.
16) Turn ON the main power switch.
F-9-137
F-9-138
9-63
9-63