Connecting The Cord - Canon imageRUNNER 2530 Service Manual

Connecting the cord

MEMO:
Install an optionally available
document glass cover or the
DADF on the machine. If the
model is the one without the
DADF, install a document cover
glass.
For how to install the DADF,
refer to the DADF Installation
Procedure.
2) Install the supplied power cord clamp with the supplied screw *.
*: Besides AU model, use the TP screw (M3 x 6). For AU model, use the stepped screw.
Insert the left leg of the power cord clamp into the machine frame.
x1
9
Installation > Making Pre-Checks > Selecting the Site of Installation
1) Insert the connector of the supplied Power cord into the AC inlet.
9 Installation > Making Pre-Checks > Selecting the Site of Installation
F-9-20 F-9-20
3) Plug the supplied Power cord in the wall outlet.
4) Peel off the protective seal from the operation panel.
5) Turn on the main power switch.
CAUTION:
The specified power must be supplied. (Rated
voltage ±10% at the rated current)
F-9-21 F-9-21
9-11
9-11