Canon imageRUNNER 2530 Service Manual page 291

8)Joint 1 connector of the heater harness to J1105 of the heater driver PCB.
9)Put 2 connectors through each hole as shown in the figure and set the heater harness in the wire saddles.
[A]
9
Installation > Reader Heater Unit-H1 Installation Procedure > Installation Procedure > Installation of Reader Harness
x9
x2
J1105
[B]
F-9-119 F-9-119
9 Installation > Reader Heater Unit-H1 Installation Procedure > Installation Procedure > Installation of Reader Harness
F-9-118 F-9-118
[C]
F-9-120 F-9-120
CAUTION:
Pay attention not to give damages on the flexible cable.
9-55
F-9-121 F-9-121
9-55