Huawei FusionModule500 Smart User Manual page 133

FusionModule500 Smart Mini Data Center
User Manual (Philippines, FusionModule500-
SU61A12S)
Step 3 Set device addresses for cabinet electronic clasp locks.
●
●
Figure 5-7 Toggle switch addresses of the cabinet electronic locks
The number indicates the DIP switch setting of the electronic clasp lock.
Table 5-12 Setting device addresses
Address
1
2
Step 4 Add the cabinet electronic clasp locks.
1.
2.
3.
Issue 02 (2021-06-30)
A cabinet electronic clasp lock is installed at the front and rear doors of the
cabinet respectively. The address for the cabinet electronic clasp lock on the
front door is an odd number, and that for the cabinet electronic clasp lock on
the rear door is an even number.
Set a device address for a cabinet electronic clasp lock by operating the toggle
switch on the cabinet electronic clasp lock. Toggle switches 1 to 6 specify the
device address in binary mode. ON indicates 1, and OFF indicates 0.
NO TICE
Toggle Toggle
Switch 1 Switch 2
ON OFF
OFF ON
Log in to the ECC800-Pro WebUI as an administrator.
Create a cabinet view in Smart Module View on the home page.
Add a cabinet electronic clasp lock.
Table 5-13 Adding a cabinet electronic clasp lock
Path
Choose System Settings
> Device Management
and click Add Device.
Copyright © Huawei Technologies Co., Ltd.
Toggle Toggle
Switch 3 Switch 4
OFF OFF
OFF OFF
Parameter Setting
Device Cabinet Electronic Clasp Lock
Attribute
Device Type Cabinet Electronic Clasp Lock
Connect To ECC800-Pro
5 Power-On Commissioning
Toggle Toggle
Switch 5 Switch 6
OFF OFF
OFF OFF
124