Huawei FusionModule500 Smart User Manual page 96

FusionModule500 Smart Mini Data Center
User Manual (Philippines, FusionModule500-
SU61A12S)
8.
9.
10. Install the upper cover of the chassis. Place the upper cover of the chassis.
Step 2 Install the floating nuts. Determine the mounting holes for the VCN510 in the
cabinet based on the cabinet device layout diagram. Insert one end of the floating
nut into the square hole from the inside of the cabinet to the outside of the
cabinet, and lock the lower frame of the square hole. Use a floating nut mounting
bar to hook the other end of the floating nut and pull the floating nut until it
snaps into the upper frame of the square hole.
Issue 02 (2021-06-30)
Figure 4-43 Installing a hard disk
Hold the disk with one hand. Use the other hand to turn over the device at a
90-degree angle. Fasten the preinstalled screws from the rear panel of the
device. Take another two #6-32UNC screws. Insert them into another two
holes on the disk (for a disk with six holes, you are advised to install the
screws into the two holes that are far away from the cable outlet) and fasten
them.
Figure 4-44 Installing a hard disk
Install a disk in No. 0 position. Install the disk in No.0 position in the same
way for installing a disk in No.1 position. During disk installation, ensure that
the direction for pushing the disk in No.0 position is opposite to that for
pushing the disk in No.1 position.
Fasten the three screws on the bottom cover of the chassis and the six screws
on the left and right sides of the chassis to fix the upper cover of the chassis.
Copyright © Huawei Technologies Co., Ltd.
4 Installation Guide
87