Secs/Gem Communication Settings - Mitsubishi Electric MELSEC iQ-R Series User Manual

2.2

SECS/GEM Communication Settings

This section shows the procedure to use a setting tool to configure SECS/GEM communication.
1.
Setting transaction information
Configure the transaction name, and then select the handshake method.
For the configuration procedure, refer to the following:
Page 59 Transaction List
2.
Setting message information
Configure items such as Stream Function, response monitoring setting, and triggers to report sending/reception.
For the configuration procedure, refer to the following:
Page 65 Message information
3.
Setting item information
Configure items such as the data type, data quantity, and control register to acquire or register data.
For the configuration procedure, refer to the following:
Page 68 Item information
4.
Communication setting
Select the SECS communication method.
When HSMS is selected, configure items such as the connection mode, IP address, and timer values.
When SECS- is selected, configure items such as the RS-232C communication port setting and timer values.
For the configuration procedure, refer to the following:
Page 74 Communication Setting
5.
Device assignment
Register the device to be used for control of triggers, registers, etc.
For the configuration procedure, refer to the following:
Page 78 Device Assignment
6.
Other settings
Configure the settings to use the alarms, spools, and other functions arbitrarily.
Always save the project after configuring each type of data and before updating the SECS/GEM
communication software pre-installed model module.
2 PROCEDURE BEFORE OPERATION
20
2.2 SECS/GEM Communication Settings