Ip Address Setting By Plc - Mitsubishi Electric MELSEC iQ-R Series User Manual

IP Address Setting By PLC

The IP address of the SECS/GEM communication software pre-installed model module can be changed by a handshake with
the SECS/GEM communication software.
Use this procedure, for example, when changing the IP address from the equipment display.
In the case of a MELSEC iQ-R series SECS/GEM communication software pre-installed model module,
replace the term "C Controller" with "C intelligent function module."
Window
[Function]  [IP Address Setting By PLC]
Displayed items
Item
IP Address (CH1) 
Setting By PLC
Setting Request
Start Register (12w)

IP Address (CH2)
Setting By PLC
Setting Request
Start Register (12w)
Description
Select this checkbox to change the IP addresses of CH1.
Configure the trigger to set the IP address of CH1.
Configure the register to store the IP address information to be configured to CH1.
Select this checkbox to change the IP address of CH2.
Configure the trigger to configure the IP address of CH2.
Configure the register to store the IP address information to be set to CH2.
7 BASIC FUNCTIONS
137
7.13 IP Address Setting
7