Toro Reelmaster 3100-D Service Manual page 73

Removing the Engine (continued)
Reelmaster ® 3100-D/3105-D
20252SL Rev A
g342503
1. Temp. shutdown switch
2. Alternator
8. Disconnect wire harness and electrical wires from the following:
A. Engine grounds to the battery and wire harness.
B. Glow plug bus and fuel stop solenoid; refer to
C. High temperature warning switch; refer to
D. High temperature shutdown switch, alternator, and low oil pressure
switch; refer to
9. Disconnect the throttle cable from the support and swivel on the speed
control lever; refer to
10. Disconnect the fuel hose from the water/fuel separator and front injector
nozzle.
11. Remove traction control cable from the neutral arm assembly on the piston
pump. Remove all hydraulic hoses from the piston an gear pumps (see
Removing the Piston Pump/Hydrostat (page
12. Remove cable ties securing the wire harness to the front lift tab and other
engine parts. Connect hoist or lift to the front and rear lift tabs; refer to
18 and Figure 19.
Make sure lift or hoist can support the total weight of the engine
before removing the cap screws from the rear bracket and engine.
13. Remove flange nut, cap screw, and washer securing three engine mounts to
the engine mounting brackets; refer to
One person should operate lift or hoist while the other person guides
the engine out of the machine.
Figure 20
3. Low oil press. switch
Figure 20.
Figure 17.
CAUTION
Figure
CAUTION
Page 4–17
Figure 18.
Figure 19.
5–80)).
16.
Engine: Service and Repairs
Figure