Installing the Reel Assembly (continued)
Reelmaster
®
3100-D/3105-D
20252SL Rev A
C. Rest the handle of the pry bar against the front roller and tighten the
spline insert closest to the pry bar. The spline inserts are installed with
thread locking compound (Loctite #243 or equivalent). Tighten the spline
insert from 115 to128 N·m (85 to 95 ft-lb). Use correct spline insert tool
(refer to
Special Tools (page
D. Position the pry bar in the same manner on the opposite end of the reel
and tighten the remaining spline insert.
16. If counterweight was removed from cutting unit, install new O-ring on counter
weight. Secure counter weight to cutting unit side plate with two (2) flange
nuts. Torque screws from 37 to 44 N·m (27 to 33 ft-lbs).
17. Install the cutting unit to the machine.
2–13)).
Page 8–25
DPA Cutting Units: Service and Repairs