Toro Reelmaster 3100-D Service Manual page 188

Removing the Hydraulic Manifold Assembly (continued)
Installing the Hydraulic Manifold Assembly
Hydraulic System: Service and Repairs
1. Park the machine on a level surface. Lower cutting units, stop engine and
engage parking brake. Remove key from the key switch.
2. Read the General Precautions for Removing and Installing Hydraulic System
Components (page
3. To prevent contamination of the hydraulic system during manifold removal,
thoroughly clean exterior of mow control manifold and fittings.
4. Disconnect the wire harness connector from the hydraulic manifold.
5. Disconnect the hydraulic lines from manifold and put caps or plugs on open
hydraulic lines and fittings. Label disconnected hydraulic lines for proper
installation.
6. Remove the two (2) nuts under the manifold that secure the manifold to
the frame.
7. If hydraulic fittings are to be removed from manifold, mark fitting orientation to
allow correct assembly. Remove fittings from manifold and discard O−rings.
1. If fittings were removed from mow control manifold, lubricate and place new
O−rings onto fittings. Install fittings into manifold openings using marks made
during the removal process to properly orientate fittings. Tighten fittings
(see Installing the Hydraulic Fittings (SAE Straight Thread O-Ring Fittings)
(page 5–8)).
2. Install the mow control manifold to the frame.
3. Remove the caps and plugs from fittings and hoses. Using labels placed
during manifold removal, properly connect hydraulic lines to manifold (see
Installing Hydraulic Hoses and Tubes (O-Ring Face Seal Fittings) (page
5–6)).
4. Connect wire harness connector to the hydraulic manifold.
5. Make sure hydraulic tank is full. Add correct fluid if necessary before
returning machine to service.
5–62).
Page 5–112 Reelmaster ® 3100-D/3105-D
20252SL Rev A