Adjustments
Neutral Switch
Adjusting
Reelmaster
®
3100-D/3105-D
20252SL Rev A
g346737
1.
Neutral switch
2.
Floor plate
The neutral switch is a normally open proximity switch that closes when the
traction pedal is in the neutral position. The neutral switch is located under the
floor plate near the traction pedal.
1. Before adjusting the traction neutral switch, check and adjust traction system
neutral position (refer to Traction Unit Operator's Manual).
To prevent traction neutral switch damage, make sure that no
components contact switch through entire traction pedal movement.
2. Park the machine on a level surface, engage the parking brake, lower the
cutting units and stop the engine. Remove the key from the key switch.
Figure 109
3.
Switch bracket
IMPORTANT
Page 6–5
Electrical System: Adjustments