Front Wheel Motor Tests (continued)
Rear Wheel Motor Test:
g344971
Reelmaster
®
3100-D/3105-D
20252SL Rev A
16. Slowly depress forward traction pedal until 68.9 to 103.4 Bar (1000 to 1500
PSI) is displayed on the pressure gauge.
Flow meter should read less than 5.7 LPM (1.5 GPM).
17. Release traction pedal, shut engine off, and record test results.
18. Rotate front wheel 120 degrees and retest. Repeat this procedure until wheel
motor has been tested in three (3) different positions.
19. Reconnect hydraulic lines to front wheel motor and repeat procedure for
remaining front wheel motor.
20. If specifications are not met, repair or replace worn wheel motor.
Model 03171 (shown)
Hydraulic fluid flows through both front wheel motors (in parallel) before passing
through the rear wheel motor (in series). To accurately test the rear wheel motor,
the front wheel motors must be allowed to rotate.
Figure 42
Page 5–35
Hydraulic System: Testing