Disassembling the Drive System (continued)
DPA Cutting Units: Service and Repairs
g230301
1.
Drive housing
2.
Drive shaft
3.
O-ring
g228652
1.
Drive shaft with right-hand threads (no
groove)
4. Remove roller brush drive shaft if needed:
A. Remove socket head screws that secure drive housing to cutting unit side
plate and remove housing from the cutting unit.
If rear roller brush drive is on left side of cutting unit, drive shaft
has left hand threads and can be identified by a groove on the
flange. If the rear roller brush drive is on right side of cutting unit,
drive shaft has right hand threads and does not have a groove on
the flange
(Figure
B. Loosen and remove drive shaft from the cutting reel.
Figure 200
4.
Socket-head screw
5.
Grommet
Figure 201
2.
Drive shaft with left-hand threads (with
groove)
IMPORTANT
201).
Page 8–44
Reelmaster
®
3100-D/3105-D
20252SL Rev A