Toro Reelmaster 3100-D Service Manual page 326

Installing the Bedbar Adjuster (continued)
DPA Cutting Units: Service and Repairs
and lock nut. Tighten lock nut to shoulder of adjuster shaft and then torque
lock nut from 21 to 27 N·m (15 to 20 ft-lb).
Note: Inside threads in bedbar adjuster shaft (item 4) are left-hand threads.
4. Apply antiseize lubricant to left hand threads threads of bedbar adjuster
screw (item 4). Thread bedbar adjuster screw into adjuster shaft (item 10).
5. Install the washer (item 11), compression spring and lock nut onto adjuster
screw.
6. Install the bedbar assembly (refer to
8–11)).
7. Adjust the cutting unit (refer to Cutting Unit Operator's Manual).
Installing the Bedbar Assembly (page
Page 8–18 Reelmaster ® 3100-D/3105-D
20252SL Rev A