Toro Reelmaster 3100-D Service Manual page 319

Removing the Bedbar Assembly (continued)
Installing the Bedbar Assembly
Reelmaster ® 3100-D/3105-D
20252SL Rev A
4. Loosen the lock nuts (item 10) on each bedbar pivot bolt.
5. Remove two (2) bedbar pivot bolts (item 9), two (2) metal washers and four
(4) plastic washers from the cutting unit side plates.
6. Remove the bedbar assembly from cutting unit.
7. Inspect flange bushings (item 7) and rubber bushings (item 6) in side plates
for wear or damage. Remove bushings and replace if necessary.
g343483
1. Cutting unit side plate
2. Locknut
3. Bedbar pivot bolt
4. Flange bushing
1. If rubber bushing was removed from either cutting unit side plate, install a
new bushing. The bushing should be installed flush with the inside of the
side plate (Figure 170).
2. If removed, install the flange bushings with flange facing outward. Apply
anti-seize lubricant to inside of flange bushing.
3. Apply anti-seize lubricant to the bedbar threads and the shoulder area of
each bedbar pivot bolt.
4. Slide one metal washer and one plastic washer onto each bedbar pivot bolt.
Contact with the reel, bedknife or other cutting unit parts can result
in personal injury. Use heavy gloves when handling the bedbar.
5. Position bedbar into cutting unit. Make sure that the top of each bedbar arm
is between washer (item 4) and adjuster screw flange.
6. Position a plastic washer between bedbar and each cutting unit side plate
(Figure 170).
Figure 170
5. Metal washer
6. Plastic washer
7. Rubber bushing
8. Bedbar
CAUTION
Page 8–11 DPA Cutting Units: Service and Repairs