Bedbar Assembly - Toro Reelmaster 3100-D Service Manual

Bedbar Assembly

g343482
1. Bedbar assembly
2. Lock nut (2 each)
3. Compression spring (2 each)
4. Washer (2 each)
Removing the Bedbar Assembly
DPA Cutting Units: Service and Repairs
5. Plastic washer (4 each)
6. Rubber bushing (2 each)
7. Flange bushing (2 each)
8. Metal washer (2 each)
Contact with the reel, bedknife or other cutting unit parts can result
in personal injury. Use heavy gloves when handling the bedbar.
1. Park the machine on a clean and level surface, lower the cutting units
completely to the ground, shut off the engine, set the parking brake, and
remove the key from the key switch.
2. Remove the cutting unit from the machine. Use the cutting unit kickstand to
support the cutting unit (refer to
3. Loosen the lock nuts (item 2 in
adjuster assembly until washer (item 2) is loose.
Figure 169
10.
CAUTION
Special Tools (page
Figure 169) on the end of each bedbar
Page 8–10
9. Bedbar pivot bolt (2 each)
Lock nut (2 each)
2–13)).
Reelmaster ®
20252SL Rev A
3100-D/3105-D