Toro Reelmaster 3100-D Service Manual page 349

Disassembling the Rear Roller Brush
Assembling the Rear Roller Brush
Reelmaster ® 3100-D/3105-D
20252SL Rev A
(Figure
C. Remove lock nut and J-bolt from both ends of the brush.
D. While rotating brush, slide brush from the shaft.
3. Disassemble roller brush components as necessary using
guide. If drive brush bearing housing (item 2) or driven pulley (item 12) need
to be removed, brush cover and drive belt removal will be necessary (refer
to Disassembling the Drive System (page
(Figure
g214814
1. Roller brush shaft
2. J-bolt
g252832
1. Bearing
2. Inner grease seal
3. Outer grease seal
1. If seals or bearings were removed from brush bearing housings, install new
components noting proper orientation as shown in
A. Pack bearings with high temp Mobil XHP-222 grease (or equivalent)
before installation.
B. Press bearing into bearing housing so that bearing contacts shoulder
in housing bore.
C. Install grease seals so that seal lips are positioned toward the brush
location as shown in
contacts bore shoulder.
195) (continued)
8–43)).
195)
Figure 196
3. Roller brush
4. Locknut
Figure 197
4. Housing (non-driven)
5. Housing (driven)
Figure 197. Press seals into housing so that seal
Page 8–41
Figure 195
Figure 197.
DPA Cutting Units: Service and Repairs
as a