Installing the Groomer Reel
Universal Groomer (Optional): Service and Repairs
1. Position cutting unit on a level surface. If cutting unit is attached to traction
unit, make sure to stop engine, engage parking brake and remove key from
the key switch.
2. Position the groomer reel between the groomer output and stub shafts.
3. Secure the groomer reel to the cutting unit with four (4) jam nuts, cap screws
and shaft clamps. Tighten the cap screws to 5 to 7 N·m (46 to 60 in-lb).
4. Check groomer reel height and mower height-of-cut settings. Adjust as
needed.
Page 9–16
Reelmaster
®
3100-D/3105-D
20252SL Rev A