Toro Reelmaster 3100-D Service Manual page 315

Installing the Hydraulic Reel Motor (continued)
Reelmaster ® 3100-D/3105-D
20252SL Rev A
g343374
1. Hydraulic reel motor
3. Rotate the motor clockwise so the motor flanges clear the cap screws in the
cutting unit side plates. Align reel motor shaft splines with cutting reel insert
splines. Slide motor shaft into reel insert.
4. Rotate the motor counter-clockwise until the motor flanges are encircling the
cap screws. Tighten two (2) cap screws to secure reel motor to cutting unit.
Figure 166
2. Cap screw
Page 8–7 DPA Cutting Units: Service and Repairs