Front Roller - Toro Reelmaster 3100-D Service Manual

Front Roller

Removing the Front Roller
Installing the Front Roller
Reelmaster ® 3100-D/3105-D
20252SL Rev A
g214676
1. Cap screw
2. Flat washer
3. Flange nut
4. HOC (roller) bracket
1. Position machine on a clean and level surface, lower cutting units, stop
engine, engage parking brake and remove key from the key switch.
2. Remove the cutting unit from the machine and place on a level working
surface. Use cutting unit kickstand (refer to
raise front roller from work surface.
3. Loosen flange nut and cap screw securing the front roller shaft to each front
height-of-cut (roller) bracket.
4. On one of the height-of-cut (roller) brackets:
A. Remove flange lock nut and carriage screw that secure bracket to the
cutting unit side plate.
B. Remove the height-of-cut (roller) bracket from the cutting unit.
5. Slide the front roller assembly from the remaining height-of-cut (roller)
bracket on the cutting unit.
6. If necessary, remove the second height-of-cut (roller) bracket from the cutting
unit.
1. Place cutting unit on a level working surface and use cutting unit kickstand
(refer to Special Tools (page
2. Inspect condition of cap screws (item 1) in both height-of-cut (roller) brackets.
Replace cap screw(s) if necessary:
A. Place two (2) flat washers on cap screw and thread flange lock nut onto
cap screw to a position 19 mm (0.750 in) from screw head.
Figure 186
5. Carriage screw
6. Cap screw
7. Flange nut
8. Front roller assembly
2–13)) to support cutting unit.
Page 8–31
Special Tools (page 2–13)) to
DPA Cutting Units: Service and Repairs