Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Media and Additional Parts
Description
Operator's Manual
Engine owner's manual
Declaration of Conformity
Note:
Determine the left and right sides of the machine from the normal operating position.
1
Adjusting the Front Cutting
Unit Roller Position
No Parts Required
Procedure
Note:
1.
Determine if you need to adjust the roller
position. The width of the cutting unit that you
install determines the roller position at the roller
support as follows:
Description
No parts required
Front hose guide (right)
Front hose guide (left)
No parts required
Hood-lock bracket
Rivet
Screw (1/4 x 2 inch)
Flat washer (1/4 inch)
Locknut (1/4 inch)
CE decal
Production year decal
Warning decal
Qty.
–
1
1
–
1
2
1
2
1
1
1
1
Qty.
1
Read the manual before operating the machine.
1
Read the manual before operating the engine.
1
This document indicates CE compliance.
•
27-inch cutting units—upper mounting holes
of the roller support.
•
32-inch cutting units—lower mounting holes
of the roller support.
11
Use
Adjust the front cutting unit roller
position.
Install the cutting units.
Prepare the machine.
Install the hood lock for European CE
Compliance.
Apply the CE decals.
Use