Bedbar Assembly - Toro Reelmaster 3100-D Service Manual

Bedbar Assembly

RIGHT
FRONT
1. Bedbar assembly
2. Lock nut (2 used)
3. Compression spring (2 used)
4. Washer (2 used)
Bedbar Removal (Fig. 24)
1. Position machine on a clean and level surface, lower
cutting units, stop engine, engage parking brake and re-
move key from the ignition switch.
2. Remove the cutting unit from the machine. Use the
cutting unit kickstand to support the cutting unit (see
Special Tools).
3. Loosen the lock nuts (item 2) on the end of each bed-
bar adjuster assembly until washer (item 2) is loose.
4. Loosen the lock nuts (item 10) on each bedbar pivot
bolt.
5. Remove two (2) bedbar pivot bolts (item 9), two (2)
metal washers and four (4) plastic washers from the cut-
ting unit side plates.
DPA Cutting Units
4
5
Figure 24
5. Plastic washer (4 used)
6. Rubber bushing (2 used)
7. Flange bushing (2 used)
Contact with the reel, bedknife or other cutting
unit parts can result in personal injury. Use
heavy gloves when handling the bedbar.
6. Remove bedbar assembly from cutting unit.
7. Inspect flange bushings (item 7) and rubber bush-
ings (item 6) in side plates for wear or damage. Remove
bushings and replace if necessary.
Page 8 − 18
2
3
1
6
7
Antiseize
Lubricant
8. Metal washer (2 used)
9. Bedbar pivot bolt (2 used)
10. Lock nut (2 used)
CAUTION
27 to 33 ft−lb
(37 to 44 N−m)
5
8
9
10
Reelmaster 3100−D