Logging In To The Neteco Client - Huawei FusionModule500 V100R021C10 User Manual

FusionModule500 Smart Mini Data Center
User Manual
Procedure
Step 1 Ensure that the power cables and ground cables are securely connected with
correct polarity and good contact.
Step 2 Ensure that the input power supply for the AC PDB is off. Use a multimeter to test
the resistance between the power outputs of the AC PDB and between the BGND
and PGND. It is required that short circuit not occur between power outputs or
between the BGND and PGND.
Step 3 Switch on the power of a rack.
Step 4 Switch on the circuit breakers of PDBs for the rack. The power supply for
equipment in the rack is available.
Step 5 Press the power button on the chassis of the server to power on the server.
Figure 5-37 TaiShan 200 server power button
----End

5.3.12.1.5 Logging In to the NetEco Client

The NetEco uses the browser/server (B/S) working mode. You can log in to the
NetEco using a web browser.
Prerequisites
Valid user name and password are available.
Procedure
Step 1 In the browser address bar, enter https://IP address of the NetEco server:31943,
and then press Enter.
● 192.168.8.11 is the default IP address of the NetEco.
● Firefox ESR 52, Chrome 57 or later is supported.
● You are advised to set the display resolution as 1920*1080 or higher.
● Make sure that the IP address of the NetEco server is not contained in the compatibility view
Step 2 Enter the User Name, Password, and click Login.
Issue 01 (2020-11-30)
NO TE
After the server is started properly, the button/indicator of its power switch is displayed
green.
NO TE
website.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
163