Commissioning Cabinet Electronic Clasp Locks - Huawei FusionModule500 V100R021C10 User Manual

FusionModule500 Smart Mini Data Center
User Manual

5.3.7 Commissioning Cabinet Electronic Clasp Locks

Prerequisites
The cabinet door can be opened and closed properly. If the cabinet door cannot be
opened and closed properly, adjust the position of the cabinet electronic clasp lock
by performing steps 1 and 2.
Procedure
Step 1 (Optional) Check whether the cabinet door lock is leveled to 2000 (+3) mm. If
not, adjust it.
Step 2 (Optional) If the cabinet door still cannot be opened after step 1 is performed,
adjust the position of the cabinet electronic clasp lock by using the slotted holes
until the cabinet door can be opened and closed properly.
Step 3 Set device addresses for cabinet electronic clasp locks.
●
●
Figure 5-9 Toggle switch addresses of the cabinet electronic locks
The number indicates the DIP switch setting of the electronic clasp lock.
Issue 01 (2020-11-30)
A cabinet electronic clasp lock is installed at the front and rear doors of the
cabinet respectively. The address for the cabinet electronic clasp lock on the
front door is an odd number, and that for the cabinet electronic clasp lock on
the rear door is an even number.
Set a device address for a cabinet electronic clasp lock by operating the toggle
switch on the cabinet electronic clasp lock. Toggle switches 1 to 6 specify the
device address in binary mode. ON indicates 1, and OFF indicates 0.
NO TICE
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
130