OfficeServ 7200
TECHNICAL MANUAL
Ports & LEDs
SM LED
LCP LED
3.2.5 LCP LEDs
The front view of the LCP board is shown in the picture below.
The components on the front panel of the LCP have the functions below:
Ports & LEDs
LINK1~LINK3
SIO
RST
RUN LED
MCP LED
Function Description
This LED indicates the status of the SmartMedia access.
- Off: The Smartmedia is not installed.
- On: The SmartMedia is installed, however is not accessed.
- Blink: The SmartMedia is installed and is being accessed.
This LED indicates the status of signaling message processing.
- Off: There's no message exchange between MCP and LCP .
- On: Messages are being sent/received to/from the LCP .
Figure 3.8 Front View of the LCP
Table 3.5 Ports and LEDs of the LCP
Ports that connect the MCP with the LCP .
Serial port (for Samsung Engineering Use ONLY)
Button for resetting the LCP board.
This LED indicates the status of the LCP .
- Off: Power is not connected.
- On: Booting.
- Blinking: Program in operation.
This LED indicates the status of signaling message processing.
- Off: There's no message exchange between MCP and LCP .
- On: Messages are being sent/received to/from the MCP .
3.8
Home Page
PART 3 SEPTEMBER 2005
Function
Table of Contents
INSTALLATION