OfficeServ 7200
TECHNICAL MANUAL
3.3 INTERFACE BOARDS
This section describes how to set jumpers and switches of an interface board, how to
install optional daughter boards to an interface board, and how to install interface
boards into slots.
3.3.1 Installing Interface Boards
Interface boards are installed on slot 1 through slot 5 of each cabinet. The following
table describes the slot locations for interface boards. The locations of Slot 0 through
slot 5 of the cabinet are described in section 3.1
Category
Trunk Cards
Station Cards
RCM or
RCM2
MIS
Figure 3.9 Installing Optional Boards
Table 3.6 Types of Interface Board and Applicable Slots
Interface Board
TEPRI
8TRK
8DLI, 8SLI, 16SLI2,
16DLI2, 8COMBO
16MWSLI
3.10
Home Page
PART 3 SEPTEMBER 2005
MFM
'Cabinet
Configuration'.
Applicable Slot
Slot 3 through slot 5 of the main cabinet
Slot 3 of the expansion cabinet
Slot 1 through slot 5 of the main cabinet
Slot 1 through slot 5 of the expansion
cabinet
Slot 1 through slot 5 of the main cabinet
Slot 1 through slot 5 of the expansion
cabinet
Table of Contents
INSTALLATION