OfficeServ 7200
TECHNICAL MANUAL
2) Push the front panel lever of the interface board until the board is completely
inserted into the OfficeServ 7200 slot.
3.3.2 Replacing Boards
If the OfficeServ 7200 system fails to operate normally due to an error on the power
supply board, control board, or interface board, replace the board with a new one.
Removing Cables
Replace a board after removing all cables connected to the board.
The procedure for replacing a board installed in a slot of a cabinet is as follows:
POWER TO THE CABINET MUST BE TURNED OFF. Failure to do so will
damage the card, cabinet and/or corrupt the data moving along the data bus.
1) Turn off the power of the cabinet.
Figure 3.11 Front Panel Lever
Figure 3.12 Turning the Cabinet Power Off
3.12
Table of Contents
Home Page
INSTALLATION
PART 3 SEPTEMBER 2005