Samsung OfficeServ 7200 Technical Manual page 59

OfficeServ 7200
TECHNICAL MANUAL
Observe the following precautions when installing batteries:
Make sure the batteries you install conform to local building, fire and safety codes.
•
Some battery types emit hydrogen gas during the charging state and may require
venting to fresh air.
Do not place batteries directly on a concrete floor. This causes them to discharge
•
very quickly.
Follow the battery manufacturer's recommended installation and maintenance
•
procedures.
PROCEDURE FOR CONNECTING EXTERNAL BATTERY
The procedure for using a battery cable to connect an external battery to the OfficeServ
7200 system is as follows:
1) Prepare the battery cable that was provided with the OfficeServ 7200 system. An
end of this battery cable consists of a white wire and a black wire.
2) Connect the white wire of the battery cable to the (+) terminal, and the black wire to
the (-) terminal of the battery. Then, connect the other end of the battery cable to
the external battery socket on the rear panel of the OfficeServ 7200 cabinet. When
using two or more OfficeServ cabinets. Connect a separate battery to each cabinet.
Figure 4.1 Connecting an External Battery (1)
4.2
Table of Contents
Home Page
INSTALLATION
PART 4 SEPTEMBER 2005