Samsung OfficeServ 7200 Technical Manual page 29

OfficeServ 7200
TECHNICAL MANUAL
Category
VoIP , Wireless
and Data
Modules
Voice Mail
The Procedure for installing the interface board to each slot is as follows:
1) Check the exterior of the interface board for any damage.
2) Align each Interface board to the guardrails of the universal slot of the OfficeServ
7200 main cabinet or expansion cabinet, and slide the Interface board into the slot.
* For LIM to operate as a managed switch, it must be installed in Slot 2 of either
cabinet and a WIM must be installed in Slot 1 next to the LIM.
Interface Board
LIM
4DSL
WIM
4WLI, MGI
SVMi-20E
Figure 3.10 Installing Interface Board into Slot
3.11
Home Page
PART 3 SEPTEMBER 2005
Applicable Slot
Slot 2 through slot 5 of the main cabinet*
Slot 2 through slot 5 of the expansion
cabinet*
Slot 1 through slot 5 of the main cabinet
Slot 1 through slot 5 of the expansion
cabinet
Slot 1 of either main cabinet or slot 1 of
expansion cabinet. Only one per system.
Slot 1 through slot 5 of the main cabinet
Slot 1 through slot 5 of the expansion
cabinet
Slots 1 through 5 of main cabinet
Slot 1 through 5 of expansion cabinet
One per system.
Table of Contents
INSTALLATION