OfficeServ 7200
TECHNICAL MANUAL
• Two screws that are already screwed in the bottom of the OfficeServ 7200 cabinet.
2.4.2 Wall Installation
The procedure for installing the OfficeServ 7200 cabinet on a wall by using a wall
bracket is as follows:
CAUTION: Only mount OfficeServ 7200 onto a wall capable of supporting
the combined weight of 2 cabinets associated blocks, cables and
peripheral equipment.
1) There are four screw holes (see [A] Figure 2.7) on the wall bracket as shown below.
Mark the four screw holes where the wall bracket should be installed.
Figure 2.6 Tools Required for Wall Installation
A
A
Figure 2.7 Wall Installation (1)
2.5
Table of Contents
Home Page
INSTALLATION
PART 2 SEPTEMBER 2005