Figure 2.8 Wall Installation; Figure 2.9 Wall Installation; Figure 2.10 Wall Installation - Samsung OfficeServ 7200 Technical Manual

OfficeServ 7200
TECHNICAL MANUAL
2) Use the electrical drill to make holes where the screw holes were marked.
3) Select appropriate screws, toggle bolts, or plastic anchors to suit the selected
mounting surface.
4) Secure the bracket to the wall using appropriate hardware.
5) There are two screws in two of the four holes at the bottom of OfficeServ 7200 cabinet
as shown below. To install on the wall, loosen the two screws to approximately 2mm as
shown in figure 2.10.

Figure 2.8 Wall Installation (2)

Figure 2.9 Wall Installation (3)

2mm

Figure 2.10 Wall Installation (4)

2.6
Table of Contents
Home Page
INSTALLATION
PART 2 SEPTEMBER 2005