Samsung OfficeServ 7200 Technical Manual page 41

OfficeServ 7200
TECHNICAL MANUAL
3.3.10 WIM (WAN INTERFACE MODULE)
This board provides data router functionality to the OfficeServ 7200. It offers a variety of
interfaces for connecting to external and internal data networks.
A WIM board can be installed in either slot 1 of the main cabinet or slot 1 of the
expansion cabinet. Only ONE WIM board can be installed per system.
If a LIM (LAN Interface Module) will be installed and the WIM is to be connected to the
LIM, then the jumper settings (JP1 ~ JP4) will determine the connection method.
Refer to the OfficeServ 7200 Data Server User Manual for WIM Configuration and
Management Information.
FRONT VIEW OF WIM BOARD
The front view of the WIM data module is shown in the picture below.
Jumper Setting 1
Figure 3.9 Jumper Setting of WIM Board
Jumper Setting 2
Figure 3.24 Jumper Setting of WIM Board
Figure 3.25 Front View of the WIM Board
3.23
Table of Contents
Home Page
INSTALLATION
PART 3 SEPTEMBER 2005
Method 1: LIM is connected to WIM via
patch cable from WIM to Ethernet port
on LIM front panel.
Method 2: WIM is connected to LIM
through the back plane thus saving an
Ethernet port on the LIM front panel. For
this connection method the LIM must
be installed in
SLOT 2.