Samsung OfficeServ 7200 Technical Manual page 24

OfficeServ 7200
TECHNICAL MANUAL
3.2.3 Connecting MCP Board to LCP Board
If the OfficeServ 7200 system consists of a Main Cabinet and an Extension Cabinet,
connect the MCP board to the LCP board using link cables to transmit and receive
signals between the control boards.
1) Three link cables are needed to connect the MCP board to the LCP board. They are
included in the LCP carton.
2) With a link cable, connect the 'Link1' port in MCP board installed in the main cabinet and
the 'Link1' port in LCP port installed in the extension cabinet. With the seconds link
cable, connect the 'Link2' port in the MCP board and 'Link2' port in the LCP board.
With the third link cable, connect the 'Link3' port in the MCP board with the 'Link3'
port in the LCP board.
LINK1
LINK2
Figure 3.5 Link Cables
LINK3
Figure 3.6 Connecting MCP Board to LCP Board
3.6
Table of Contents
Home Page
INSTALLATION
PART 3 SEPTEMBER 2005