Samsung OfficeServ 7200 Technical Manual page 42

OfficeServ 7200
TECHNICAL MANUAL
The components on the front panel of the WIM have the functions below.
Ports & LEDs
DMZ
LAN
SERIAL
WAN1, WAN2
SIO
RST
RUN LED
DMZ LED
SERIAL LED
WAN1, WAN2 LED This LED indicates the operation status of the WAN.
LAN LED
Refer to Figure 3.26 for SIO cable pin outs.
Table 3.13 Ports and LEDs of the WIM
Function Description
Internal port that bypasses firewall (de-militarized zone)
Ethernet port connected with the internal private network.
Port that connects the serial dedicated line that inter-works with the
V.35 (WAN connection to external network). This cable can be
ordered separately (See figure 3.26 for pin outs).
WAN interface ports (WAN Ethernet 1: 10/100 BASE-T, WAN Ethernet
2: 10 BASE-T) to connect to external network.
Serial Console Access
Button for resetting the WIM module
This LED indicates the operation status of the WIM.
- Off: The WIM board is in an abnormal status or the power is not
being supplied.
- On: The WIM board is operating properly.
This LED indicates the operation status of the DMZ.
- Off: The link is not connected to external network using this
interface.
- On: The link is connected to external network.
This LED indicates the operation status of the LAN.
- Off: The link is not connected to external network using this
interface.
- On: The link is connected to external network.
- Off: The link is not connected to external network using this
interface.
- On: The link is connected to external network.
This LED indicates the Operation Status of the LAN
- Off: Link is not connected to LAN.
- On: Link is in connected to LAN.
3.24
Table of Contents
Home Page
INSTALLATION
PART 3 SEPTEMBER 2005