2
Disconnecting the
Pressure-Sense Tube
No Parts Required
Procedure
1. Press in the collar for the tube coupler in the end cap
of the right boom-section valve
1. Ported-cap fitting (end of
the right boom-section
valve)
2. Tube coupler
2. Pull the pressure-sense tube for the dash gauge out of
the tube coupler
(Figure
(Figure
5).
Figure 5
3. Pressure-sense tube
5).
3
Disconnecting the Wire
Harness from the Valves
No Parts Required
Procedure
1. Remove the screw that secures the 3-contact connector
of the wire harness labeled
right spray valve
1. Right spray valve
2. Center spray valve
3. Left spray valve
2. Remove the 3-contact connector of the wire harness
from the spray valve
3. Repeat steps
1
and
the wire harness labeled
LEFT SPRAY VALVE
4. Remove the screw that secures the 3-contact connector
of the wire harness labeled
right master spray valve
7
RIGHT SPRAY VALVE
(Figure
6).
Figure 6
4. Spray-valve connector
5. 3-contact connector
6. Screw
(Figure
6).
2
for the 3-contact connectors of
CENTER SPRAY VALVE
.
MASTER SPRAY VALVE
(Figure
7).
from
and
from