Installing The Return Hose - Toro Multi Pro 1750 Installation Instructions Manual

1. Agitation-nozzle assembly
2. Retainer
14

Installing the Return Hose,

Agitation Supply Hose, and
Bypass Hose
Parts needed for this procedure:
1 Return hose—2.5 x 72 cm (1 x 27-7/8 inches)
1 Agitation supply hose—2.5 x 72 cm (1 x 28-1/4 inches)
Bypass hose—2.5 x 110 cm (1 x 43-1/2
1 inches)—machines without the optional spray wand
or electric hose reel kit
Installing the Return Hose
1. Assemble the quick-connect fitting (straight barbed) of
the return hose—2.5 x 71 cm (1 x 27-7/8 inches) onto
the quick coupling of the rate valve with the retainer
(small) that is supplied with the hose
Figure 63
3. 90° quick-connect fitting
4. Quick-connect fitting
(agitation throttle valve)
(Figure
1. Quick-connect fitting (rate
control valve)
2. Quick-connect fitting
(straight barbed—return
hose)
3. Retainer (small)
4. Front of the machine
2. Route the return hose down and toward the T-fitting
located inboard of the pressure-relief valve as shown
64).
in Figure
31
Figure 64
5. Return hose—2.5 x 71 cm
(1 x 27-7/8 inches)
6. 90° barbed fitting
7. Retainer (large)
8. T-fitting (inboard)
65.