Installing The Center Spray-Valve Connector; Installing The Rate-Valve Connector; Installing The Left Spray-Valve Connector - Toro Multi Pro 1750 Installation Instructions Manual

Installing the Center Spray-Valve
Connector
1. Align the wire insulation colors of the DIN harness to
the wire insulation colors of the 3-pin adapter for the
center spray valve as shown in the wire table for the
center spray valve.
Wiring Table—Center Spray Valve
Wire color codes—DIN wire
harness
Brown
Blue
Yellow/green
2. Insert the wire of the DIN wire harness into the
butt-splice connector of the 3-pin adapter
3. Center the crimping tool over the butt-splice connector
and wires and crimp the connector securely.
4. Repeat steps 2 and
5. Use a heat gun to shrink the insulating sleeves of the
3 butt-splice connectors.
Installing the Left Spray-Valve
Connector
1. Align the wire insulation colors of the DIN harness to
the wire insulation colors of the 3-pin adapter for the
left spray valve as shown in the wire table for the left
spray valve.
Wiring Table—Left Spray Valve
Wire color codes—DIN wire
harness
Brown
Blue
Yellow/green
2. Insert the wire of the DIN wire harness into the
butt-splice connector of the 3-pin adapter
3. Center the crimping tool over the butt-splice connector
and wires and crimp the connector securely.
4. Repeat steps 2 and
5. Use a heat gun to shrink the insulating sleeves of the
3 butt-splice connectors.
Wire color codes—3-pin
adapter
Pink
Black
White
3 for the 2 remaining wires.
Wire color codes—3-pin
adapter
Pink
Black
White
3 for the 2 remaining wires.

Installing the Rate-Valve Connector

1. Cut off the butt-splice connectors for the pink wire
and black wires of the 4-pin adapter
1. 4-pin adapter
2. Black wire
2. Strip 8 mm (5/16 inch) of insulation from the pink and
black wires of the 4-pin adapter
Note: You will connect the pink and black wires of
the 4-pin adapter in
Connector (page
1. Black wire (4-pin adapter)
2. Pink wire (4-pin adapter)
3. Align the brown wire of the DIN harness with the gray
wire of the 4-pin adapter for the rate valve
refer to the wire table for the rate valve.
19
(Figure
Figure 37
3. Pink wire
4. Butt-splice connector
(Figure 38).
Installing the Master-Spray Valve
22).
Figure 38
3. Removed section of wire
insulation—8 mm (5/16
inch)
(Figure
37).
39);