Installing The Bypass Hose - Toro Multi Pro 1750 Installation Instructions Manual

Figure 67
1. Agitation supply hose—2.5 x 72 cm (1 x 28-1/4 inches)
3. Assemble the quick-connect fitting (straight barbed)
of the agitation supply hose onto the quick coupling
of the agitation throttle valve with the retainer that is
supplied with the hose
Installing the Bypass Hose—Machines
without the Optional Spray Wand Kit or
Electric Hose Reel Kit
If your machine has the optional spray wand kit or electric
hose reel kit, skip this procedure. You will install the bypass
hose in 17 Installing the Shutoff Valve and Hoses for the
Optional Spray Gun Kit or Electric Hose-Reel Kit (page
1. Assemble the straight barbed fitting of the bypass
hose—2.5 x 110 cm (1 x 43-1/2 inches) into the rear
port of the T-fitting at the top of the sprayer tank
(Figure 68).
(Figure 67).
1. T-fitting
2. Retainer
40).
3. Straight barbed fitting
4. Bypass hose—2.5 x 110
cm (1 x 43-1/2 inches)
2. Secure the straight barbed fitting to the T-fitting
with the retainer that you removed in step
Disconnecting the Return, Sprayer-Supply, and Bypass
Hoses (page
3. Route the bypass hose to the bypass valve located
above the master-spray valve as shown in
33
Figure 68
5. Flange—bypass valve
(master-spray valve
position)
6. Straight barbed fitting
7. Gasket—25 x 35 mm (1 x
1-3/8 inches)
8. Flange clamp—40 to
64 mm (1-9/16 to 2-1/2
inches)
14).
5 of
Figure 69.