Installing The Master-Spray Valve Connector - Toro Multi Pro 1750 Installation Instructions Manual

Figure 44
1. Brown wire (cutting the
conductor)
2. Blue wire (cutting the
conductor)
B. Wrap the end of the brown wire with electrical
tape to seal the wire
C. Wrap the end of the blue wire with electrical tape
to seal the wire
D. Fold the brown wire and blue wire to the yellow
and green wire and wrap the 3 wires together with
the electrical tape
3. Taping the end of the
brown wire and blue wire
4. Taping wires together
(Figure 44).
(Figure 44).
(Figure 44).
Installing the Master-Spray Valve
Connector
1. Insert the yellow and green wire of the DIN wire
harness into the butt-splice connector on the white
wire of the 3-pin adapter for the master-spray valve
(Figure 45).
1. 4-pin adapter (rate valve)
2. 3-pin adapter (agitation
valve)
3. 3-pin adapter
(master-spray valve)
2. Center the crimping tool over the butt-splice connector
and wires and crimp the connector securely.
3. Align the black wire of the 4-pin adapter for the rate
valve and the black wire of the 3-pin adapter of the
agitation valve, and the blue wire of the DIN wire
harness with the black wire of the 3-pin adapter for
the master-spray valve; refer to the wire table for the
master-spray valve
22
Figure 45
4. White wire (3-pin
adapter—master-spray
valve)
5. Yellow and green
wire (DIN wire
harness—master-spray
valve)
(Figure 46).