Assembling The Manifold Valve; Installing The Agitation-Manifold Valve - Toro Multi Pro 1750 Installation Instructions Manual

Assembling the Manifold Valve

1. Check the condition of the outlet fitting O-rings
(section valve manifold only), end cap O-rings, back
seating O-rings, and ball seat for damage or wear
(Figure 118 and Figure
Note: Replace any damaged or worn O-rings or seats.
2. Apply grease to the valve stem and insert it into the
valve-stem seat (Figure 118
3. Install the valve stem and seat into the manifold and
secure the stem and seat with the stem retainer
118 and Figure 119).
4. Ensure that the back seating O-ring and the ball seat
are aligned and seated into the end-cap fitting
118 and Figure 119).
5. Install the end-cap-fitting assembly onto the manifold
body until the flange of the end-cap fitting touches the
manifold body (Figure 118
the end-cap fitting an additional 1/8 to 1/4 turn.
Note: Use caution to prevent damage to the end of
the fitting.
6. Insert the ball into the valve body
Note: The valve stem should fit inside the ball-drive
slot. If the valve stem does not fit, adjust the position
of the ball (Figure 120).
Figure 120
7. Turn the valve-stem assembly so that the valve is closed
(Figure 117).
8. Repeat steps 4 and
assembly.

Installing the Agitation-Manifold Valve

1. Align the flange of the agitation bypass valve, 1 gasket,
and the end-cap-fitting flange of the agitation-valve
manifold (Figure 121).
Note: If needed, loosen the mounting hardware for
the pressure-filter head as needed to provide clearance.
119).
and Figure 119).
and Figure 119), then turn
(Figure 120).
5 for the other end-cap-fitting
(Figure
(Figure
1. Flange (pressure-filter
head)
2. Flange (agitation bypass
valve)
3. Flange (reducer coupling)
4. Flange clamp
2. Assemble the agitation bypass valve, gasket, and
agitation-valve manifold with a clamp, and tighten by
hand (Figure
3. Align a gasket between the flanges of the pressure-filter
head and the agitation-valve manifold
4. Assemble the pressure-filter head, gasket, and
agitation-valve manifold with a clamp, and tighten by
hand (Figure
5. Align a gasket between the flanges of the agitation-valve
manifold and the reducer coupling
6. Assemble the agitation-valve manifold, gasket, and
reducer coupling with a clamp, and tighten by hand
(Figure
7. Align a gasket between the flanges of the agitation-valve
manifold and the adapter fitting for the agitation
throttle valve
8. Assemble the agitation-valve manifold, gasket, and
adapter fitting with a clamp, and tighten by hand
(Figure
9. If you loosened the mounting hardware for the
pressure-filter head, tighten the nut and bolt to 1978 to
2542 N∙cm (175 to 225 in-lb).
57
Figure 121
5. Gasket
6. Quick connect
7. Manifold (agitation valve)
8. Flange
(manifold—agitation
valve)
121).
121).
121).
(Figure 121).
121).
(Figure 121).
(Figure 121).