Manufacturer Recommendations; Pm Form - GE ApexPro Service Manual

Manufacturer recommendations

PM form

2001989-203C
WARNING
EQUIPMENT FAILURE/HEALTH HAZARD — The manufacturer
does not in any manner, assume the responsibility for performing the
recommended maintenance schedule, unless an Equipment
Maintenance Agreement exists. The sole responsibility rests with
the individuals, hospitals, or institutions utilizing the device. Failure
on the part of all responsible individuals, hospitals or institutions,
employing the use of this device, to implement the recommended
maintenance schedule may cause equipment failure and possible
health hazards.
To make sure the ATS hardware remains in proper operational and functional order, a
good maintenance schedule must be adhered to. The manufacturer recommends the
following:
Visual Inspection: Should be performed by service personnel upon receipt of the
equipment, one time per year thereafter, and prior to servicing the unit.
Cleaning: Should be performed by service personnel upon receipt of the
equipment, one time per year thereafter, and each time the unit is serviced.
Calibration: No calibration is required.
Electrical Safety Checks: Should be performed by service personnel upon receipt
of the equipment, one time per year thereafter, and every time the unit is serviced.
Checkout Procedure: Should be performed by qualified service personnel upon
receipt of the equipment, one time per year thereafter, and each time the unit is
serviced.
Replacing the Hard Drive: You should replace the hard drive as deemed
necessary. See Hard drive on page 7-18.
For the latest PM form regarding this product, contact GE Service. Make a copy of
the GE Unity Network Information Suite Server PM form and use the copy to help
guide you as you go through this section of the manual. The PM form can then be
archived for reference after completion of all the steps required to completely test the
equipment.
ApexPro™ Telemetry
Checkout
8-5