Boot Failure; Ats Connection Failure - GE ApexPro Service Manual

Area
Mounting hardware
Power source
Symptoms of power source problems include static discharge, resetting problems, and noise.

Boot failure

Task
Check for connection problems
Check for power supply
problems
Check for short circuit

ATS connection failure

Network connection
2001989-203C
Loose or missing screws or other hardware, especially fasteners used as connections to ground planes on
PCBs.
Receiver System mounted loosely or near vibration.
Faulty wiring, especially AC outlet.
Circuit not dedicated to system.
Verify that all components are connected correctly and the unit is plugged into a
known good outlet.
Ensure that all cables are properly seated.
Shut down, turn off and unplug the ATS.
Follow all antistatic precautions.
on page 8-11.
properly seated.
Check
Verify that all components are connected
correctly and the unit is plugged into a known
good outlet.
Ensure that all cables are properly seated.
Has the power switch on the front of the ATS
been firmly pressed?
Are the power supply switches switches on?
Are power supply fans spinning?
Ensure power supply LEDs are lit.
Is UPS starting and working correctly?
Ensure both power supplies firmly seated and
secured in the ATS.
LEDs are blinking erratically, turning amber, or
staying off.
NOTE
Keyboard/Video/Mouse (KVM) may be required in certain cases to access the
ATS desktop.
Connect to ATS through the network using Webmin.
service interface on page 4-7.
ApexPro™ Telemetry
Look for the following problems:
See Controlling electrostatic discharge damage
Remove all access panels and ensure all internal components are
Short circuit may exist.
Troubleshooting
Correct
Correctly/firmly ensure all components/
cables properly connected/seated.
Press power switches firmly.
Firmly seat/secure power supplies.
Power supplies/UPS may be
malfunctioning.
See Log onto the Webmin
6-3