General - Control Function - ABB i-bus KNX Product Manual

11.5.8 General — Control function
Options:
– Heating : For operating a heat-based automatic single-room control. The temperature is
regulated to the setpoint value defined in the parameter. The "Controller type" and "Heating
type" can be programmed for optimal control.
– Heating with additional stage : In addition to the control function described under heating, the
additional stage enables the activation of an additional heating circuit. This type of additional
stage is used, for example, to quickly heat up a bathroom with floor heating via a heated
towel rack.
– Cooling : For operating a cooling-based automatic single-room control. The temperature is
regulated to the setpoint value defined in the parameter. The "Controller type" and "Cooling
type" can be programmed for optimal control.
– Cooling with additional stage : In addition to the control function described under cooling, the
additional stage enables the activation of an additional cooling device. This type of
additional stage is used, for example, to quickly cool a room via an added cooling device.
– Heating and cooling : For operating a two-wire or four-wire system used to heat or cool a
room. Switching between heating and cooling takes place using a central switch (two-wire
system) or is carried out manually and / or automatically via the single room temperature
controller (four-wire system).
– Heating and cooling with an additional stage: In addition to the heating and cooling
functions, one additional stage each with an autonomous controller type can be
programmed.
Note
This parameter is only available if the "Device function" parameter is set on
"Single device" or "Master device".
Product manual 2CKA001473B9482
Description of application and parameters
Heating
Heating with additional stage
Cooling
Cooling with additional stage
Heating and cooling
Heating and cooling with additional stage
Application "Function block RTC"
│78