Fan Coil Settings For Cooling; Fan Coil Settings For Cooling - Speed Level 1 To 5 Up To Control Value (0 To 255) Cooling; Fan Coil Settings For Cooling - Fan Speed Level Limit Cooling For Eco Mode; Fan Coil Settings For Cooling - Maximum Fan Speed Level Cooling For Eco Mode - ABB i-bus KNX Product Manual

11.5.128 Fan coil settings for cooling

Note
This parameter is only available if the "Device function" parameter is set on
either "Single device" or "Master device" and the "Control value type" parameter
is set on "Fan coil". In addition, the "Control function" parameter must be set on
either "Cooling", "Cooling with additional stage", "Heating and cooling" or
"Heating and cooling with additional stages".
11.5.129 Fan coil settings for cooling — Speed level 1 to 5 up to control value (0 to 255) cooling
Options:
In this parameter, the control values of the controller are assigned to fan speed levels. This
assignment is used if the fan speed levels are transmitted together with the control values.
Note
■
■
■
11.5.130 Fan coil settings for cooling — Fan speed level limit cooling for eco mode
Options:
This parameter limits the fan speed level when the system is switched to eco mode.

11.5.131 Fan coil settings for cooling - Maximum fan speed level cooling for eco mode

Options:
Specifies the maximum possible fan speed level when the system is switched to eco mode.
Note
The parameter is only adjustable if the "Fan speed level limit cooling in Eco
mode" parameter is set on "Yes".
Product manual 2CKA001473B9482
Description of application and parameters
Setting option between 0 - 255
These level settings should be adjusted to match the settings in the fan coil
actuator.
Setting the "Control value type" to "Fan coil" in the control parameters is only
useful for one of either the basic stage or the additional stage. Setting the
basic and additional stage parameters to fan coil is not useful, since the
control of only one fan coil actuator each for heating and cooling is
supported.
The "Fan speed level 4 - 5 up to control value (0 - 255) cooling" parameters
are available only when the "Number of fan speed levels" is set on "5 levels".
No
Yes
Setting option between 0 - 5
Application "Function block RTC"
│122